Laserfiche WebLink
ZONING § 25-4-68 <br /> Section 25-4-65. Grounds for approval or denial. <br /> The director shall approve an application for recognition of a de minimis structure <br /> position discrepancy unless: <br /> (a) The discrepancy is greater than the difference as allowed by the de minimis <br /> structure position discrepancy definition, or <br /> (b) The director finds that the improvement was placed with knowledge that it would <br /> violate the minimum yard or open space requirements; or <br /> (c) The improvement could be moved, or the discrepancy otherwise corrected, without <br /> significant expense, difficulty, or hardship to the applicant. <br /> (2002, ord 02-70, sec 3.) <br /> Section 25-4-69. Recognition of de minimis structure position discrepancy. <br /> If the director accepts the application for recognition of de minimis structure <br /> position discrepancy, the director shall notify the applicant in writing that the <br /> discrepancy is not a violation of the zoning code and that it may remain in place without <br /> a variance. <br /> (2002, ord 02-70, sec 3.) <br /> Section 25-4-70. Disclosure. <br /> A de minimis structure position discrepancy shall be disclosed by the owner to <br /> subsequent purchasers of the property in question. <br /> (2002, ord 02-70, sec 3.) <br /> Section 25-4-71. Appeals. <br /> The director's decision with respect to a de minimis structure position discrepancy <br /> is appealable to the board of appeals. <br /> (2002, ord 02-70, sec 3.) <br /> Article 5. Zoning District Regulations. <br /> Division 1. RS, Single-Family Residential Districts. <br /> Section 25-5-1. Purpose and applicability. <br /> The RS (single-family residential) district provides for lower or low and medium <br /> density residential use, for urban and suburban family life. It applies to areas having <br /> facilities, and to carry out the above stated purpose. <br /> (1996, ord 96-160, sec 2; ratified April 6, 1999.) <br /> Section 25-5-2. Designation of RS districts. <br /> Each RS (single-family residential) district shall be designated on the zoning map <br /> by the symbol "RS" followed by a number which specifies the required minimum <br /> building site area in thousands of square feet. <br /> (1996, ord 96-160, sec 2; ratified April 6, 1999.) <br /> Planning Dep$. 25-73 <br /> Exhibit—- 2 <br />