Laserfiche WebLink
Street Light Notes, cont'd <br />EXISTING POLE INSTALLATIONS: <br />1. When street lights are to be installed on existing wooden utility poles within the County <br />ROW, the Traffic Division shall be contacted in order to initiate the joint pole <br />application process with HELCO. No street lights shall be installed until the pertinent <br />joint pole applications have been approved. <br />2. Upon signed approval by the Traffic Division, street lights on existing wooden utility <br />poles can be installed (4 maximum) by the Traffic Division at a cost of $2,500 per <br />street light. The developer shall submit a check payable to the County, Director of <br />Finance, along with the subdivision number, DPW folder number, TMK number, utility <br />pole 6 digit ID numbers, and GPS coordinates. <br />3. When street lights are installed within the County ROW with existing street lights, the <br />new street light installations shall conform to the existing adjacent street light <br />configuration on that roadway. <br />STREET LIGHTING ELECTRICAL PRACTICES: <br />1. The Contractor shall provide all necessary secondary circuit extensions to the nearest <br />HELCO secondary. If street lights are installed before HELCO installs their secondary, <br />the contractor is responsible for coordinating and informing HELCO of street light <br />locations and pole contacts. <br />2. The contractor shall inscribe the month and year of installation on photoelectric (PE) <br />cells and lamps. All PEs shall have the north index facing north. <br />3. All overhead wired street light fixtures shall be bonded to the neutral wire in the <br />fixtures. All bonded street light fixtures shall have a 2"X2" reflective green sticker <br />placed at the base of the wire opening on the aluminum street light arms, signifying <br />that the street lights are bonded. <br />4. All underground street light wiring shall have a #6 AWG (minimum) ground wire routed <br />in series from the neutral ground source point to each street light ground rod for a <br />street light fixture ground point. A ground test measurement should indicate a <br />maximum of 25 ohms to ground. <br />5. A minimum 8'X5/8" copper ground rod shall be used for each street light foundation. <br />MATERIALS: <br />1. All labor and materials shall have a minimum one-year warranty from date of final <br />acceptance. <br />Page 2 of 4 <br />